Ip Address - D-Link xStack DES-3800 Series User Manual

Jumbo Frame
Syslog Global State
DVMRP State
PIM DM State
RIP State
OSPF State
ARP Aging Time (0-
65535)
CPU Interface
Filtering
Click Apply to implement changes made.

IP Address

The IP Address may initially be set using the console interface prior to connecting to it through the
Ethernet. If the Switch IP address has not yet been changed, read the introduction of the xStack DES-
3800 Series CLI Manual or return to Section 4 of this manual for more information. To change IP
settings using the web manager you must access the IP Address menu located in the Administration
folder.
To configure the Switch's IP address:
Open the Administration folder and click the IP Address menu link. The web manager will display
the Switch's current IP settings in the IP configuration menu, as seen below.
To manually assign the Switch's IP address, subnet mask, and default gateway address:
1. Select Manual from the Get IP From drop-down menu.
2. Enter the appropriate IP Address and Subnet Mask.
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
This field will enable or disable the Jumbo Frame function on the Switch. The default is
Disabled.
Enables or disables Syslog State; default is Disabled.
The user may globally enable or disable the Distance Vector Multicast Routing
Protocol (DVMRP) function by using the pull down menu.
The user may globally enable or disable the Protocol Independent Multicast - Dense
Mode (PIM-DM) function by using the pull down menu.
The user may globally enable or disable the Routing Information Protocol (RIP)
function by using the pull down menu.
The user may globally enable or disable the Open Shortest Path first (OSPF) function
by using the pull down menu.
The user may globally set the maximum amount of time, in minutes, that an Address
Resolution Protocol (ARP) entry can remain in the Switch's ARP table, without being
accessed, before it is dropped from the table. The value may be set in the range of 0-
65535 minutes with a default setting of 20 minutes.
The user may globally enable or disable the CPU Interface Filtering function by using
the pull down menu.
Figure 6- 2. IP Address Settings window
32