D-Link xStack DES-3800 Series User Manual page 210

VLAN Name
Source IP
Destination IP
Desc. (0-63)
Protocol
To view the settings of a previously correctly configured rule, click
view the following screen:
The following window is the CPU Interface Filtering Rule Table for Packet Content.
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
forwarded to. Once this field is specified, packets accepted by the Switch that match this
priority are forwarded to the CoS queue specified previously by the user.
Replace priority with − Click the corresponding box if you want to re-write the 802.1p
default priority of a packet to the value entered in the Priority field, which meets the
criteria specified previously in this command, before forwarding it on to the specified
CoS queue. Otherwise, a packet will have its incoming 802.1p user priority re-written to
its original value before being forwarded by the Switch.
For more information on priority queues, CoS queues and mapping for 802.1p, see the
QoS section of this manual.
Allows the entry of a name for a previously configured VLAN.
Source IP Address - Enter an IP Address mask for the source IP address.
Destination IP Address- Enter an IP Address mask for the destination IP address.
This field allows the user to enter a DSCP value in the space provided, which will
instruct the Switch to examine the DiffServ Code part of each packet header and use
this as the, or part of the criterion for forwarding. The user may choose a value between
0 and 63.
This field allows the user to modify the protocol used to configure the Access Rule
Table; depending on which protocol the user has chosen in the Access Profile Table.
Figure 10- 28. CPU Interface Filtering Rule Display - IP
194
in the Access Rule Table to