Glossary - D-Link xStack DES-3800 Series User Manual

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch

Glossary

1000BASE-LX: A short laser wavelength on multimode fiber optic cable for a maximum length of
550 meters
1000BASE-SX: A long wavelength for a "long haul" fiber optic cable for a maximum length of 10
kilometers
100BASE-FX: 100Mbps Ethernet implementation over fiber.
100BASE-TX: 100Mbps Ethernet implementation over Category 5 and Type 1 Twisted Pair cabling.
10BASE-T: The IEEE 802.3 specification for Ethernet over Unshielded Twisted Pair (UTP) cabling.
aging: The automatic removal of dynamic entries from the Switch Database which have timed-out and
are no longer valid.
ATM: Asynchronous Transfer Mode. A connection oriented transmission protocol based on fixed
length cells (packets). ATM is designed to carry a complete range of user traffic, including voice, data
and video signals.
auto-negotiation: A feature on a port, which allows it to advertise its capabilities for speed, duplex
and flow control. When connected to an end station that also supports auto-negotiation, the link can
self-detect its optimum operating setup.
backbone port: A port which does not learn device addresses, and which receives all frames with an
unknown address. Backbone ports are normally used to connect the Switch to the backbone of your
network. Note that backbone ports were formerly known as designated downlink ports.
backbone: The part of a network used as the primary path for transporting traffic between network
segments.
bandwidth: Information capacity, measured in bits per second that a channel can transmit. The
bandwidth of Ethernet is 10Mbps, the bandwidth of Fast Ethernet is 100Mbps.
baud rate: The switching speed of a line. Also known as line speed between network segments.
BOOTP: The BOOTP protocol allows you to automatically map an IP address to a given MAC
address each time a device is started. In addition, the protocol can assign the subnet mask and default
gateway to a device.
bridge: A device that interconnects local or remote networks no matter what higher-level protocols are
involved. Bridges form a single logical network, centralizing network administration.
broadcast: A message sent to all destination devices on the network.
broadcast storm: Multiple simultaneous broadcasts that typically absorb available network bandwidth
and can cause network failure.
console port: The port on the Switch accepting a terminal or modem connector. It changes the parallel
arrangement of data within computers to the serial form used on data transmission links. This port is
most often used for dedicated local management.
CSMA/CD: Channel access method used by Ethernet and IEEE 802.3 standards in which devices
transmit only after finding the data channel clear for some period of time. When two devices transmit
simultaneously, a collision occurs and the colliding devices delay their retransmissions for a random
amount of time.
data center switching: The point of aggregation within a corporate network where a switch provides
high-performance access to server farms, a high-speed backbone connection and a control point for
network management and security.
Ethernet: A LAN specification developed jointly by Xerox, Intel and Digital Equipment Corporation.
Ethernet networks operate at 10Mbps using CSMA/CD to run over cabling.
Fast Ethernet: 100Mbps technology based on the Ethernet/CD network access method.
Flow Control: (IEEE 802.3z) A means of holding packets back at the transmit port of the connected
end station. Prevents packet loss at a congested switch port.
281