Rip - D-Link xStack DES-3800 Series User Manual

To add a new entry, click the Add button, revealing the following window to configure:
The following fields can be set:
Parameter
IP Address
MAC Address
After entering the IP Address and MAC Address of the Static ARP entry, click Apply to implement
the new entry. To completely clear the Static ARP Settings, click the Clear All button.

RIP

The Routing Information Protocol is a distance-vector routing protocol. There are two types of
network devices running RIP - active and passive. Active devices advertise their routes to others
through RIP messages, while passive devices listen to these messages. Both active and passive routers
update their routing tables based upon RIP messages that active routers exchange. Only routers can
run RIP in the active mode.
Every 30 seconds, a router running RIP broadcasts a routing update containing a set of pairs of
network addresses and a distance (represented by the number of hops or routers between the
advertising router and the remote network). So, the vector is the network address and the distance is
measured by the number of routers between the local router and the remote network.
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
Figure 8- 8. Static ARP Settings window
Figure 8- 9. Static ARP Table – Add a New Entry window
Description
The IP address of the ARP entry.
The MAC address of the ARP entry.
NOTE: The Switch supports up to 255 static ARP entries.
110