Switch Description
The Switch is equipped with unshielded twisted-pair (UTP) cable ports providing dedicated 10 or 100
Mbps bandwidth. The Switch has 24 UTP ports and Auto MDI-X/MDI-II convertible ports that can be
used for unlinking to another switch. These ports can be used for connecting PCs, printers, servers,
hubs, routers, switches and other networking devices. The dual speed ports use standard twisted-pair
cabling and are ideal for segmenting networks into small, connected sub networks for superior
performance. Each 10/100 port can support up to 200 Mbps of throughput in full-duplex mode. In
addition, the Switch has 2 combo 1000 Base-T/SFP ports on the front panel and two 1000 Base-T on
the back. These gigabit combo ports are ideal for connecting to a server or network backbone. See the
"Ports" section below for differences between the front and rear Gigabit combo ports.
This Switch enables the network to use some of the most demanding multimedia and imaging
applications concurrently with other user applications without creating bottlenecks. The built-in
console interface can be used to configure the Switch's settings for priority queuing, VLANs, and port
trunk groups, port monitoring, and port speed.
Features
IEEE 802.3ad Link Aggregation Control Protocol support.
•
IEEE 802.1x Port-based and MAC-based Access Control
•
IEEE 802.1Q VLAN
•
IEEE 802.1D Spanning Tree, IEEE 802.1W Rapid Spanning Tree and IEEE 802.1s Multiple
•
Spanning Tree support
Access Control List (ACL) support
•
Single IP Management support
•
Access Authentication Control utilizing TACACS, XTACACS and TACACS+
•
Dual Image Firmware
•
Simple Network Time Protocol support
•
MAC Notification support
•
System and Port Utilization support
•
System Log Support
•
Support port-based enable and disable
•
Address table: Supports up to 16K MAC addresses per device
•
Supports a packet buffer of up to 32M bytes
•
Supports Port-based VLAN Groups
•
Port Trunking with flexible load distribution and fail-over function
•
IGMP Snooping support
•
SNMP support
•
Secure Sockets Layer (SSL) and Secure Shell (SSH) support
•
Port Mirroring support
•
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
2