Bridge Multicast Address - D-Link DES-3010GA Cli Manual

D-Link DES-3010FA/GA CLI Reference Guide

bridge multicast address

The bridge multicast address Interface Configuration (VLAN) mode command registers a MAC-layer multicast
address in the bridge table and statically adds ports to the group. To unregister the MAC address, use the no form
of this command.
Syntax
bridge multicast address {mac-multicast-address | ip-multicast-address}
bridge multicast address {mac-multicast-address | ip-multicast-address} [add | remove] {ethernet interface-list
| port-channel port-channel-number-list}
no bridge multicast address {mac-multicast-address | ip-multicast-address}
Parameters
•
add — Adds ports to the group. If no option is specified, this is the default option.
•
remove — Removes ports from the group.
•
mac-multicast-address — A valid MAC multicast address.
•
ip- multicast-address — A vaid IP multicast address.
•
interface-list — Separate nonconsecutive Ethernet ports with a comma and no spaces; a hyphen is used to
designate a range of ports.
•
port-channel-number-list — Separate nonconsecutive port-channels with a comma and no spaces; a hyphen
is used to designate a range of ports.
Default Configuration
No multicast addresses are defined.
Command Mode
Interface configuration (VLAN) mode
User Guidelines
If the command is executed without add or remove, the command only registers the group in the bridge database.
Static multicast addresses can only be defined on static VLANs.
Examples
The following example registers the MAC address:
Console(config)# interface vlan 8
Console(config-if)# bridge multicast address 01:00:5e:02:02:03
The following example registers the MAC address and adds ports statically.
Console(config)# interface vlan 8
Console(config-if)# bridge multicast address 01:00:5e:02:02:03 add ethernet 1-4, 7
Page 31