Section 3. Address Table Commands; Bridge Address - D-Link DES-3010GA Cli Manual

D-Link DES-3010FA/GA CLI Reference Guide

Section 3. Address Table Commands

bridge address

The bridge address Interface Configuration (VLAN) mode command adds a MAC-layer station source address to
the bridge table. To delete the MAC address, use the no form of this command.
Syntax
bridge address mac-address {ethernet interface | port-channel port-channel-number} [permanent | delete-on-
reset | delete-on-timeout | secure]
no bridge address [mac-address]
Parameters
•
mac-address — A valid MAC address.
•
interface — A valid Ethernet port.
•
port-channel-number — A valid port-channel number.
•
permanent — The address can only be deleted by the no bridge address command.
•
delete-on-reset — The address is deleted after reset.
•
delete-on-timeout — The address is deleted after "age out" time has expired.
•
secure — The address is deleted after the port changes mode to unlock learning (no port security com-
mand). This parameter is only available when the port is in the learning locked mode.
Default Configuration
No static addresses are defined. The default mode for an added address is permanent.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
Using the no form of the command without specifying a MAC address deletes all static MAC addresses belonging
to this VLAN).
Example
The following example adds a permanent static MAC-layer station source address 3aa2.64b3.a245 on port 7 to
the bridge table.
Console(config)# interface vlan 2
Console(config-if)# bridge address 3aa2.64b3.a245 ethernet 7 permanent
Page 29