Port Storm-Control Include-Multicast - D-Link DES-3010GA Cli Manual

D-Link DES-3010FA/GA CLI Reference Guide

port storm-control include-multicast

The port storm-control include-multicast Interface Configuration (Ethernet) mode command counts multicast
packets in broadcast storm control. To disable counting multicast packets, use the no form of this command.
Syntax
port storm-control include-multicast [unknown-unicast]
no port storm-control include-multicast
Parameters
•
unknown-unicast — Specifies also counting unknown unicast packets.
Default Configuration
Multicast packets are not counted.
Command Modes
Interface Configuration (Ethernet) mode
User Guidelines
To control multicasts storms, use the port storm-control broadcast enable and port storm-control broadcast
rate commands.
Example
The following example enables counting broadcast and multicast packets on Ethernet port 3.
Console(config)# interface ethernet 3
Console(config-if)# port storm-control include-multicast
Page 93