Show Fiber-Ports Optical-Transceiver - D-Link DES-3010GA Cli Manual

show fiber-ports optical-transceiver

The show fiber-ports optical-transceiver Privileged EXEC command displays the optical transceiver diagnos-
tics.
Syntax
show fiber-ports optical-transceiver [interface] [detailed]
Parameters
•
interface — A valid Ethernet port. (Full syntax: port)
•
detailed — Detailed diagnostics.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
To test optical transceivers, ensure a fiber link is present.
Examples
The following examples display the optical transceiver diagnostics.
Console# show fiber-ports optical-transceiver
Port Temp
---- ----
10 OK
Temp – Internally measured transceiver temperature.
Voltage - Internally measured supply voltage.
Current – Measured TX bias current.
Output Power – Measured TX output power.
Input Power – Measured RX
Tx Fault – Transmitter fault
LOS – Loss of signal
N/A - Not Available, N/S - Not Supported, W - Warning, E - Error
Voltage Current
------- -------
OK OK
received power.
Page 152
PHY Diagnostics Commands
Power
Output Input
------ -----
OK OK
TX Fault LOS
------- ---
E OK