Exec-Timeout - D-Link DES-3010GA Cli Manual

exec-timeout

The exec-timeout Line Configuration mode command sets the interval that the system waits until user input is
detected. To return to the default configuration, use the no form of this command.
Syntax
exec-timeout minutes [seconds]
no exec-timeout
Parameters
•
minutes — Specifies the number of minutes. (Range: 0 - 65535)
•
seconds — Specifies additional time intervals in seconds. (Range: 0 - 59)
Default Configuration
The default configuration is 10 minutes.
Command Mode
Line Configuration mode
User Guidelines
To specify no timeout, enter the exec-timeout 0 command.
Examples
The following example configures the interval that the system waits until user input is detected to 20 minutes.
Console(config)# line console
Console(config-line)# exec-timeout 20
Page 136
Line Commands