Dot1X Multiple-Hosts - D-Link DES-3010GA Cli Manual

802.1x Commands

dot1x multiple-hosts

The dot1x multiple-hosts Interface Configuration mode command enables multiple hosts (clients) on an 802.1X-
authorized port, where the authorization state of the port is set to auto. To return to the default configuration, use
the no form of this command.
Syntax
dot1x multiple-hosts
no dot1x multiple-hosts
Default Configuration
Multiple hosts are disabled.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command enables the attachment of multiple clients to a single 802.1X-enabled port. In this mode, only one
of the attached hosts must be successfully authorized for all hosts to be granted network access. If the port
becomes unauthorized, all attached clients are denied access to the network.
For unauthenticated VLANs, multiple hosts are always enabled.
Multiple-hosts must be enabled to enable port security on the port.
Examples
The following command enables multiple hosts (clients) on an 802.1X-authorized port.
Console(config-if)# dot1x multiple-hosts
Page 336