Logging Buffered - D-Link DES-3010GA Cli Manual

Syslog Commands

logging buffered

The logging buffered Global Configuration mode command limits syslog messages displayed from an internal
buffer based on severity. To cancel using the buffer, use the no form of this command.
Syntax
logging buffered level
no logging buffered
Parameters
•
level — Specifies the severity level of messages logged in the buffer. Possible values: emergencies, alerts,
critical, errors, warnings, notifications, informational, debugging.
Default Configuration
The default severity level is informational.
Command Mode
Global Configuration mode
User Guidelines
All the syslog messages are logged to the internal buffer. This command limits the messages displayed to the
user.
Example
The following example limits syslog messages displayed from an internal buffer based on severity level debug-
ging.
Console(config)# logging buffered debugging
Page 252