Spanning-Tree Disable - D-Link DES-3010GA Cli Manual
Layer 2 switch, managed 8 port 10/100base-tx with gigabit & fiber uplinks
Hide thumbs
Also See for DES-3010GA:
- Cli manual (361 pages) ,
- Web user manual (281 pages) ,
- Manual (348 pages)
Table of Contents
Advertisement
D-Link DES-3010FA/GA CLI Reference Guide
spanning-tree disable
The spanning-tree disable Interface Configuration mode command disables spanning tree on a specific port. To
enable spanning tree on a port, use the no form of this command.
Syntax
spanning-tree disable
no spanning-tree disable
Default Configuration
Spanning tree is enabled on all ports.
Command Modes
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example disables spanning-tree on Ethernet port 5.
Console(config)# interface ethernet 5
Console(config-if)# spanning-tree disable
Page 227
Hide quick links:
Advertisement
Table of Contents
