Throttle Curve (See Acro 3.3.14); Prog. Mix (See Acro 3.3.1); At10Ii Using Tutorials - RadioLink AT10II Instruction Manual

Goals
In ADVANCE menu find the
ATTITUDE function.
Set the
Assign the switch to control attitude.
ATTITUDE of
Ex: SW3 is SWC，SW2 is SWB
MULTIROTO
R.
Set the rate in each attitude.
Ex: ATTI is 60%.
Close

6.2.2 THROTTLE CURVE (see ACRO 3.3.14)

6.2.3 PROG. MIX (see ACRO 3.3.1)

RadioLink AT10 + R10D Binding
https://www.youtube.com/watch?v=rhdB6KgVsMw
RadioLink AT10 + PRM-01 Telemetry Module
https://www.youtube.com/watch?v=uWSxWrYUwAg
AT10 Firmware Upgrade
https://www.youtube.com/watch?v=SU-AclRNwWY&t=47s
RadioLink AT10 and NAZA in SBus
https://www.youtube.com/watch?v=nxU8RnwjTs4&t=372s
Mission Planner Calibration and Radiolink AT10 setup Flight Modes
https://www.youtube.com/watch?v=3jtOA4m1csA&t=26s
3 Axis CNC Gimbal with Storm32 Controlled by AT10
https://www.youtube.com/watch?v=iPna6LhoBZ8&t=19s
RADIOLINK AT10. SETUP FOR APM 2.6. APM 2.8
https://www.youtube.com/watch?v=S7DdYLgSZ7E&t=12s
Steps

AT10II Using Tutorials

Inputs
urn on the transmitter,
menu (If ADVANCE,
Press MODE to ATTITUDE
to SW3, ,
to SW2,
,
to rate-ATTI,
83
Radiolink Electronic Ltd
www.radiolink.com
for 1 sec. to BASIC
again)
to SWC，
to SWB，
to 60%，
，