High/Low Pitch (Hi/Lo-Pit) - RadioLink AT10II Instruction Manual

Goals
Fine-tune hovering with the hovering
adjustments. Remember these affect
only the hovering (normal) condition.
Adjust throttle and collective pitch
curves until model hovers nicely. In
flight,adjust collective pitch and
throttle
curves near hover point independently
with HOV-THR and HOV-PIT knobs.
Store new settings after flight.

5.3.6 HIGH/LOW PITCH (HI/LO-PIT):

This function may be used to adjust the curves high and low side individually for each flight
condition (normal, idle-up 1, idle-up 2, idle-up 3, throttle hold).
ADJUSTABILITY:
• You may define high and low side rate trim knobs (the high side pitch trim control is defined as the
right side lever at initial setting).
• The conditions are activated in the CONDITION SELECT function.
• Both adjustments may be set to MANUAL, temporarily turning off the knob.
• Adjustments may be memorized and then return the knobs to center point to use that amount of
adjustment, allows easy use of the trimming knobs for multiple models.
Goals
Set up a high pitch curve
in the idle-up 1condition.
Steps
Open the HOV-THR function
Optional: change which
knob adjust search hovering
curve. NULL locks in curve
in last stored position.
Close
Open the HOV-PIT function.
Close
Steps
Open the HI/LO-PIT
Select the idle-up 1 condition
Set the rate (Ex:80%)
Optional：Change which knob
adjusts high pitch curve.
Close
ADVANCE ,
knob and direction
Inputs
to BASIC menu,
to HI/LO-PIT.
to COND
to HI-PIT
to VR ,
74
Radiolink Electronic Ltd
www.radiolink.com
Inputs
to BASIC. again to
to HOV-THR.
to VR , to desired
to HOV-PIT. Repeat.
again to ADVANCE menu.
, to IDL1
to 80%
,
to desired knob and direction.