Throttle-Needle Mixing (Acro/ Heli) - RadioLink AT10II Instruction Manual

Adjustability:
• Separate curves for each switch position are available.
• Moving and deleting the curve point: The curve point (-STK-) can be moved to the left or right by
turning the DIAL (up to 2% in front of the adjoining point) and deleted/returned by pressing the DIAL
for one second alternately.
Goals
Base point: Adjust base point of
throttle curve until engine idles
reliably.
-Out-:output,servo position.
-STK-: curve point, stick position.

3.3.15 THROTTLE-NEEDLE mixing (ACRO/ HELI):

Steps
Open THR-CURVE
Activate the function.
Adjust the 1 st point
Optional: assign the switch.
Optional: Move the curve
point.(Ex: point 3)
Optional: delete the curve
point. And return the curve
point.(Ex: point 3)
Adjust the next point.
Close
ACRO
Inputs
to BASIC .
to THE-CURVE,
to MIX.PUSH
to P1(-out-).PUSH
servo position
to SW.PUSH,
to P3 (-stk-),PUSH
curve point to move to left or right.
to P3 (-stk-).
the curve point.
to P3 (-stk-)，
Repeat as needed.
HELI
52
Radiolink Electronic Ltd
www.radiolink.com
again to ADVANCE
to ON.
to desired
to desired switch.
to desired
for 1sec.to delete
for 1sec.to return