Set Glid Type - RadioLink AT10II Instruction Manual

Adjust travels as needed to
match model's recommended
throws (usually listed as high
rates).
Set up dual/triple rates and
exponential (D/R, EXP).
(Note that in the middle of the
left side of the screen is the
name of the channel and the
SWITCH position you are
adjusting. Two or even three
rates maybe set per channel by
simply choosing the desired
SWITCH and programming
percentages with the SWITCH in
each of its 2/3 position.)
Move flap control from the (VR
(A)) dial to the left slider.
[VR(D)](AUX-CH) .

4.2 SET GLID TYPE

TYPE: (GLID 1A+1F), GLID (2A+1F), GLID (2A+2F)
In BASIC menu choose
END POINT.
Adjust the servos' end
points. (Ex: flap servo).
Close the function.
Choose D/R,EXP
Choose the desired
control, and set the first
(Ex: high) rate throws and
exponential.
Set the second (Ex: low)
rate throws and
exponential.
Optional: change dual
rate SWITCH assignment.
Ex: elevator to SWITCH
G with 3 positions.
In the BASIC menu, open
AUX-CH.
Choose CH5. Change
primary control to VR(D).
Change other channels as
needed.
Close
55
to END POINT.
to FLAP
VR(A). to desired travel.
，
VR(A). to desired travel.
，
Repeat as needed.
to D/R,EXP
to CH
，
A to UP position. Screen reads ELEV [UP]
to D/R
Elevator Stick. ,
Elevator Stick. to set.
（Normally the same for both direction）
to EXP
Elevator Stick
Elevator Stick
to D/R , A to down position. Repeat
above to set low rate.
to SW , to G,
Repeat steps above to set 3rd rate.
to AUX-CH
to CH5 , to VR(D)。
Repeat steps above to set other channels.
Radiolink Electronic Ltd
www.radiolink.com
to CH2(ELEV).
to set .
to set
to set
G to center.