Throttle Needle (See Acro Menu 3.3.15); Prog Mix (See Acro Menu 3.3.1); Condition - RadioLink AT10II Instruction Manual

ADJUSTABILITY:
• Initial: 100%
• adjusting range: 0-200%
Goals
To prevent damaging the swash
linkage by simultaneous operation of
the ailerons and elevators, set the
limit point where swash throw stops.
Adjust the rate at the maximum
swash tilt by simultaneous operation
of the ailerons and elevators.

5.3.12 THROTTLE NEEDLE (see ACRO MENU 3.3.15)

5.3.13 PROG MIX (see ACRO MENU 3.3.1)

5.3.14 CONDITION

Revo., curves for idle-ups are often v-shaped to provide proper rudder input with negative pitch
and increased throttle during inverted flight. (Rudder is needed to counter the reaction whenever
there is increased torque. In inverted flight, throttle stick below half has increased throttle and
negative pitch, therefore increasing torque and rotating the helicopter unless the revo. mix is also
increasing appropriately.)
Additional flight conditions are available specifically for helicopters. These additional flight
conditions contain different throttle curves, collective pitch curves, revo. mixing, and trims (except
IDLE-3) to make the helicopter perform certain maneuvers more easily. Lastly, the gyro and dual
rate functions may be set to provide separate rates per condition selected, including one for each
idle-up.
Additional idle-ups may be used to maximize the helicopter's flight characteristics in certain
types of flight (i.e. fast forward motion, backward) or maneuvers (loops, rolls, stall turns), or even
the same maneuver but changing from heading-hold/AVCS gyro mode to normal gyro mode. The
AT10II provides 3 idle-ups to allow the modeler 3 additional setups along with the normal flight
condition. (Note that IDL3 does not include governor settings.)
Steps
Open SWASH-RING
function.
Activate the function.
Adjust the rate Ex: 90%
Close
79
Radiolink Electronic Ltd
www.radiolink.com
Inputs
to BASIC menu,
ADVANCE
to SWASH-RING
to MIX to ACT
，
to RATE
，
again to
to 90%，