Crestron iLux CLS-C6 Operation Manual page 55

Crestron CLS/CLSI-C6 & CLS/CLSI-C6M
Operations Guide - DOC. 6347B
Function name Open Momentary/Open Full (All, Group 1-6)
Behavior A quick tap of the button will perform a "Full Open". A maintained press
will perform a "Momentary Open" until the button is released.
If the shade is already moving in the open direction, a tap will stop it:
So, if you tap the button once, it will start moving to full open; then if you
tap it again, it will stop.
If the shade is moving in the close direction, a tap will send to full open.
A longer press will do a "Momentary Open" until the button is released.
LED On while button is pressed
Applies To Remote Button
Rocker N/A
Behavior
Notes When changing direction, there may be a short time when the shade is
stopped before it starts moving in the opposite direction. This is the
"lockout time" for the shade controllers. This time is fixed for the C2N-
SSC shades; it can be changed for the SDC and SDC-DC controllers
via iLux Designer.
Shade commands with "All" parameter will only affect all the shade
groups connected to the given CLS-C6 module. They will not pass from
one CLS-C6 module to the other (either when directly connected or
when linked through Cresnet system). To accomplish this function for all
shades in a multi-unit system, use SIMPL programming.
Function name Close Momentary/Close Full (All, Group 1-6)
Behavior Same as "Open Momentary/Open Full Shade Group 1-6", except Close.
LED On while button is pressed
Applies To Remote Button
Rocker N/A
Behavior
Notes Same as "Open Momentary/Open Full Shade Group 1-6."
Function name Open/Stop/Close/Stop (All, Group 1-6)
Behavior Function will alternate between the "Full Open", "Stop" and "Full Close"
commands for the specified shade group(s) each time the button is
pressed.
LED On while button is pressed
Applies To Standard Rocker, Shifted Rocker, Remote Button, Up/Down (All only)
Rocker Pressing center of the button will act same as non-rocker
Behavior open/stop/close/stop. Pressing only one side of the button while
stopped, will always send it in specified direction – rather than in
opposite of last direction. Pressing any part of the button while shade is
moving will stop it.
For Up/Down button bottom button = left button => close.
Notes Shade commands with "All" parameter will only affect all the shade
groups connected to the given CLS-C6 module. They will not pass from
one CLS-C6 module to the other (either when directly connected or
when linked through a Cresnet system). To accomplish this function for
all shades in a multi-unit system, use SIMPL programming.
Lighting System: CLS/CLSI-C6 & CLS/CLSI-C6M • 51
™
iLux
™
iLux Lighting System
top button = right button => open.