Replacing The Function Button Label - Crestron iLux CLS-C6 Operation Manual

™
iLux Lighting System
• iLux
™
24
Lighting System: CLS/CLSI-C6 & CLS/CLSI-C6M
Crestron CLS/CLSI-C6 & CLS/CLSI-C6M
1. At the prompt, type <WHITELEDLEVEL> or <GREENLEDLEVEL>
and press Return. The system displays, for example:
White led brightness level = 70
iLux>
2. To change the brightness, type <WHITELEDLEVEL ##> or
<GREENLEDLEVEL ##> where ## is any number from 1 to 100.
3. When you press Return, the respective LEDs go to their new level.
Glow Mode Brightness
Glow mode is enabled when all lighting loads are turned off. In Glow mode, all the
white LEDs turn on at a very low level to make it possible to find the unit in a
darkened room.
1. Press the OFF button to select the Off scene (all lights off).
2. At the prompt, type <WHITELEDGLOWLEVEL> and press Return.
The system displays:
White led glow level = 7
iLux>
3. To change the brightness, type <WHITELEDGLOWLEVEL ##> where ##
is any number from 1 to 100.
(The glow level should be much lower than the normal LED brightness.)
4. When you press Return, the white LEDs go to their new level.

Replacing the Function Button Label

Each CLS-C6 is supplied with a pre-printed label sheet, in white, almond, or black to
match the unit's color. The sheet contains two labels showing the standard Scene 1 –
Scene 6 button labels, three labels with clear spaces that permit you to write in single
line button names, and three labels with clear spaces that permit you to write in
two-line button names to accommodate shift functions. The label sheet is micro-
perforated to make it easy to separate the desired label from the sheet. Carefully fold
the sheet along the perforations to snap them apart.
1. To replace the label on the unit, remove the front panel assembly by
carefully pulling out and up from the bottom edge.
2. Carefully pull the label cover from the top edge at each side of the unit.
Refer to the following illustration.
3. Remove the original label and replace it with the new label.
4. Replace the label cover, make sure the small tabs on the bottom edge are
inserted in the slots on the unit cover, and snap into position.
5. Install the front cover assembly on the unit by lining it up at the top and
pressing the bottom edge until it snaps into position.
Operations Guide - DOC. 6347B