Crestron iLux CLS-C6 Operation Manual page 11

Crestron CLS/CLSI-C6 & CLS/CLSI-C6M
Operations Guide - DOC. 6347B
Connectors, Controls, & Indicators (continued)
# CONNECTORS,
CONTROLS, &
INDICATORS
5 Motion Detector (CLS/CLSI-
C6M only)
6 Mini Phone Jack
7 Two-Digit Display
8 Lights Pushbutton and LED
9 Shades Pushbutton and
LED
^, v, Save, and Cancel
10
Pushbuttons
11 Reset Button
12 Shift LEDs
13 Up/Down Pushbutton
14 ON Button
15 OFF Button
Continued on next page
iLux
™
iLux
DESCRIPTION
The built-in motion detector can be used to activate
a particular scene when there is activity in the room,
and/or to activate a particular scene (typically Off)
when there is no activity for a specified period. A
limited number of actions are available when
programmed locally; more are available using the
iLux Designer software program.
Use this 3.5mm TRS mini-phone jack, located on
the front panel, as an RS-232 programming port, to
communicate with the iLux Designer and Crestron
Toolbox to configure the unit, and to upgrade the
unit's firmware.
In Standard mode, the display is normally blank,
except when showing scene fade time. The Min and
Sec LEDs illuminate when the display is indicating
time in minutes or in seconds, respectively. In Setup
mode, the display uses a two-character mnemonic
to indicate which specific aspect of the CLS-C6 you
are changing. As these are being adjusted, the
display may indicate values. (Refer to "Setup Mode"
on page 13 for details.)
Use this switch to select the Lights mode. The LED
illuminates when the mode is selected. Refer to
"Lights Mode" on page 34 for details.
Use this switch to select the Shades mode. The
LED illuminates when the mode is selected. Refer
to "Shades Mode" on page 35 for details.
Use these pushbuttons to navigate and execute
setup functions. The Save and Cancel LEDs
indicate when these functions are active. Refer to
"Setup Mode" on page 13 for details.
If the unit stops functioning and does not respond to
button pushes, use a thin object such as a paperclip
to activate this switch. The unit reboots (all lighting
loads go off, the two-digit display shows "– –," and
all lighting loads go to their previous state).
These LEDs are covered by the label strip, but are
easily visible through the strip when they are
illuminated. When the Shift mode is enabled via
programming, there can be two functions defined for
each of the six function buttons. The unit will always
be in "upper" or "lower" shift mode as indicated by
the state of the LEDs.
This three position "rocker" switch is programmable
for master lights control (all lights or last scene),
master shade control, or as a "shift" button to allow
a second set of functions for the six function
buttons.
The ON button always acts as a recall scene button
for the "On" scene. Refer to "Standard Mode" On
page 31 for details.
The OFF button always acts as a recall scene
button for the Off scene, which will always turn all
lighting loads off and open the air-gap relay. Refer
to "Standard Mode" On page 31 for details.
Lighting System: CLS/CLSI-C6 & CLS/CLSI-C6M • 7
™
Lighting System