Crestron iLux CLS-C6 Operation Manual page 21

Crestron CLS/CLSI-C6 & CLS/CLSI-C6M
Operations Guide - DOC. 6347B
If setup is exited without pressing the Save button, the original values will be
retained. For lighting loads where adjustment has been made, lights will jump to the
original high-end level. Light levels will not change on lighting loads where no
adjustment was made. When the Save button is pressed, Setup mode will be exited,
the new values will be saved, and the lights will not change.
Setup Button Functions (bF)
This Setup mode is used to define the behavior of the buttons on the CLS-C6 unit
itself, and on remote keypads if you want behavior other than the default. (Remote
keypads must be ID'd, using auto-discovery, prior to this, which will set them to
their default functions.) To enter this mode:
•
First enter Setup mode and scroll to the "bF" option (using the ^ and v buttons).
Then use the Up/Down button to scroll through the available button functions
and values. This will scroll through all values for each function before
proceeding to the next function.
•
If you press and hold the button, it will auto repeat. During auto-repeating, when
it reaches the minimum or maximum value for that function, it will stop. The
next button push will then increment/decrement to the next function.
A available functions and values are as shown in the following table. (Other
functions require a PC with iLux Designer software to configure them.)
BUTTON FUNCTION
Recall Scene
Toggle Scene
Control Shade (open/stop/close/stop)
Master Raise/Lower (last scene)
1. To assign a function to a certain button or buttons, first scroll to the desired
function and value. Then, press each appropriate function button or remote
button to assign the displayed function and value to that button.
When the button is released, the LED for that button should flash once to
indicate that programming took place.
2. Next, use the Up/Down button to scroll to the next function and value to be
assigned, and assign the desired buttons. Repeat this procedure for each
function and value to be assigned.
3. After assigning all button functions, press Save, and the button function
information will be saved. If you press Cancel, or exit by some other
mechanism (e.g., timeout), the state will return to what it was before you
entered Setup mode.
•
Note that the ON and OFF buttons on the CLS-C6 cannot be programmed. The
operation of the Up/Down button is programmed using the "ud" setup function.
•
If you try to program an illegal button (e.g., the ON button, or program a remote
keypad button as master raise/lower-Up/Down), LED will flash on three times to
indicate that setting did not take place, and the two-digit display will show "Er."
•
Note that other button functions, including "shifted" functions, can be defined
using the iLux Designer configuration program.
™
iLux
™
iLux
CODE
F1
F2
F3
F4
Lighting System: CLS/CLSI-C6 & CLS/CLSI-C6M • 17
Lighting System
POSSIBLE VALUES
oF,on,1-15
on,1-15
AL, 1-6
uP, dn, ud (rockers only)