Linear Module; Clunk Sound While Y Axes Are Moving; Linear Module Burns Out Suddenly; Linear Module Only Moves In One Direction - Snapmaker 2.0 Troubleshooting Manual

Linear Module

Clunk Sound While Y Axes Are Moving
Possible Cause
• The two Y axes are not in sync.
Actions
1. Swap one of the Y axes with the X axis. In most cases, the issue should be solved.
2. If the issue still exists, swap one Y axis with one of the Z axes.

Linear Module Burns out Suddenly

Possible Cause
• The Linear Module is broken.
Actions
Replace the Linear Module.

Linear Module Only Moves in One Direction

Possible Cause
• The end-stop switch is stuck.
Actions
1. Connect the machine to your computer with a USB cable.
2. Launch the Snapmaker Luban. In the console, input M119, and check the status of the end-stop switch.
- If X_min or X_max is displayed as TRIGGERED, then the end-stop switch of the X Linear Module might be
stuck.
- Similarly, if Y_min, Y_max, Z_min, or Z_max is displayed as TRIGGERED, then the end stop switch of the Y or
Z Linear Modules might be stuck.
|
05