Table of Contents
Advertisement
Hardware
4.3 Loosen the screw of the probe sensor so that it can be adjusted.
4.4 Find a credit card (or anything with a height of about 1 mm). Move the module down until the nozzle tip
touches the Print Sheet; then put the card under the probe sensor so that the sensor is approximately
1 mm higher than where the nozzle tip is.
4.5 Tighten the screw of the probe sensor.
4.6 Reassemble the 3D Printing Module correctly.
|
22
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 2.0 and is the answer not in the manual?
Questions and answers