Table of Contents
Advertisement
Actions
1. Replace the hot end before trying any of the following steps. A spare hot end is included in the box. For how
to change the new hot end kit,
Note: If it's hard to remove the blobs from the current hot end, heat the nozzle up to 230 ℃ and try again.
2. Lower the printing speed. In Luban, go to Printing Settings > Click + + > put in lower values in Speed.
3. Recalibrate. For detailed instruction on calibration, refer to the Quick Start Guide.
4. Try another filament.
see https://youtu.be/2anRrb_R63o.
|
17
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 2.0 and is the answer not in the manual?
Questions and answers