Table of Contents
Advertisement
4. On the Touchscreen, go to Control > Nozzle.
5. Wait for the nozzle to heat up until you can tap the Load or Unload button. Make sure the nozzle temperature
matches the working temperature of the filament you are using (ABS generally requires a higher temperature
than PLA, for example). Tap Load to see if the gear inside the 3D Printing Module rotates.
- If it does, then use a metal stick to poke the feeding hole (see picture below). Make sure the filament inside
is all cleaned up. Close the small window to try again and see whether the filament can load properly.
|
15
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 2.0 and is the answer not in the manual?
Questions and answers