3D Printing; 3D Printing Module Isn't Detected - Snapmaker 2.0 Troubleshooting Manual

Hardware

3D Printing

3D Printing Module Isn't Detected
If you turn on the machine, and the Touchscreen displays an error message Snapmaker tech-team, then it might
be that the 3D Printing Module is not detected by the machine.
Possible Causes
• The toolhead cable is broken.
• The Linear Module or the Controller is broken.
• The 3D Printing Module is broken.
Actions
1. Replace the current toolhead cable with one of the interchangeable cables (see picture below). Use it to
connect the machine to your computer. In the Luban console, input M1999 and see if it displays 3DPRINT
Module in the second line from the bottom.
Toolhead Cable
- If it does, then it means the 3D Printing Module is detected. The toolhead cable is broken. Replacing a new
toolhead cable can solve the issue.
-If it doesn't, then it means the 3D Printing Module isn't detected. In that case, try the next step.
|
10
Y Conversion Cable Z Conversion Cable