Luban Shows "The Machine Is Not Ready - Snapmaker 2.0 Troubleshooting Manual

Luban Shows "The machine is not ready"
When trying to connect the machine to the Snapmaker Luban, it shows The machine is not ready or cannot open
the port.
Possible Causes
• You haven't installed the CH340 driver.
• You attempted to connect to the wrong port.
Actions
1. Download and install the CH340 driver from
2. Find the correct port following the steps below. Then launch Luban and try again.
2.1 Connect the machine to a computer via a USB cable, and then turn on the machine.
2.2 Press the Win key and the R key at the same time.
2.3 Type devmgmt.msc in the search box and click OK.
2.4 Expand Ports (COM & LPT), and the correct COM port to connect is the one with CH340 in its name.
https://snapmaker.com/product/snapmaker-2/downloads.
|
45