Laser Is Discontinuous Or Weak - Snapmaker 2.0 Troubleshooting Manual

2. Change the Laser Height manually. On the Touchscreen, tap Failed > Settings > Laser > Adjust Laser Height.
Set the Laser Height to 23.0mm and then recalibrate. If the Touchscreen keeps showing Failed, and several lines
fail to be burned, then lower the laser height (to 21.5 mm or 19 mm, for example), and try again.
Laser Is Discontinuous Or Weak
The Laser Module emits weak light and doesn't engrave at its full power, and therefore the module can't finish
Auto Focus.
Possible Causes
• The Enclosure's door is open during Auto Focus.
• The laser is too high.
• The Laser Module is broken.
Actions
1. Either close the Enclosure's doors or go to Enclosure > Settings to disable the door detection feature.
2. Change the Laser height manually. On the Touchscreen, tap Settings > Laser > Adjust Laser Height. Set
the Laser Height to 23.0mm and then recalibrate. If the Touchscreen keeps showing Failed, and several lines
won't be burnt out, lower the laser height (to 21.5 mm or 19 mm, for example), and try again.
|
25