Table of Contents
Advertisement
Hardware
4. Wait for the nozzle to reach 200 ℃ , tap Load or Unload, and see if the gear in the module rotates.
- If it does, then change the toolhead cable.
- If it doesn't, then the Controller is broken. It might be that the customer has connected the toolhead cable in
the wrong direction, and the toolhead and the Controller is damaged as a result. You will need to first replace
the Controller. Then, check if the 3D Printing Module and Laser Module works with the new Controller.
If not, these modules may also be broken and need to be replaced.
5. Replace the toolhead cable with the Y or Z conversion cable to see if the Laser Module emits light. If it does,
then the previous toolhead cable is broken and needs to be replaced.
Toolhead Cable
|
30
Y Conversion Cable
Z Conversion Cable
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 2.0 and is the answer not in the manual?
Questions and answers