Table of Contents
Advertisement
2. Replace the current toolhead cable with one of the interchangeable cables (see picture below). See if this
solves the problem. If not, then the Laser Module is broken and needs to be replaced.
Toolhead Cable
Laser Won't Turn off
The blue laser light of the Laser Module turns on and can't be turned off via the Touchscreen or Snapmaker
Luabn.
Possible Causes
• The Toolhead cable is broken.
• The Laser Module or the Controller is broken.
Actions
1. Replace the current Toolhead cable with one of the interchangeable cables (see picture below). See if this
solves the problem. If not, please go to step 2.
Toolhead Cable
2. Find out which one is the problem first, Laser Module or the Controller.
2.1 Get your 3D Printing Module, turn on the machine, and press to open the latch on the 3D Printing
Module. By checking the 3D Printing Module, you will know if the Controller is working.
Y Conversion Cable
Y Conversion Cable
Z Conversion Cable
Z Conversion Cable
|
33
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 2.0 and is the answer not in the manual?
Questions and answers