Concluding Steps - Fujitsu PRIMERGY GX2460 M1 Upgrade And Maintenance Manual

System board and components
Ê Install the heat sink with on the new system board, see section
heat sink" on page
Ê Connect all cables to the system board:
I
For the cable plan, see chapter

13.3.1.4 Concluding steps

Ê Install all memory modules, see section
page 165.
I
Ensure that you install each memory module in the slot it was located
before the replacement.
Ê If applicable, remove the riser modules, see section
riser module" on page 112
module" on page
"Installing the air duct" on page 55
Ê
"Reassembling" on page 50
Ê
Ê Install the PSUs, see section
Ê Connect all external cables.
"Connecting the power cord" on page 53
Ê
"Verifying the system time settings" on page 59
Ê
"Updating or recovering the BIOS and BMC" on page 58
Ê
Ê For memory configurations with LRDIMMs: set the memory operation mode
in the BIOS in the same way as before replacing the system board. For more
information, see the corresponding BIOS Setup Utility reference manual.
"Looking for MAC addresses" on page 63
Ê
"Updating the NIC configuration file in a Linux environment" on page 61
Ê
Ê If applicable, reconfigure your network settings in the operating system
according to the original configuration of the replaced controller (expansion
card or onboard).
I
Configuration of network settings should be performed by the
customer. For more information, see section
settings recovery" on page
Ê If applicable, restore LAN teaming configurations.
218
183.
and "Removing the left or right PCIe/GPU riser
133.
"Installing a hot-plug PSU" on page
212.
Upgrade and Maintenance Manual
"Appendix B" on page
"Installing memory modules" on
"Removing the middle
"Note on network
"Installing the
243.
67.
GX2460 M1