Installation Of The Wine Guardian Remote Sensor; Mounting The Remote Sensor - Wine Guardian WGS40 Installation, Operation And Maintenance Manual

Installation of the Wine Guardian Remote Sensor

Mounting the remote sensor

Fig.1
A splitter device has been supplied within the Remote Sensor kit. The splitter device
must be mounted at the WG unit as shown. DO NOT mount the splitter device at the
back of the Remote Interface Controller or to the back of the Remote Sensor as this
WILL cause component or system damage
49
The Remote Sensor is a combination temperature and
humidity sensor only. It is designed to be mounted within
the wine cellar and can be used in combination with the
Remote Interface Controller or up to three additional
Remote Sensors to read and control multiple areas within
the wine cellar.
Disconnect the communication cable from the side of the Wine
Guardian unit and the remote sensor. Install the communication
cable within the wall and/or ceiling structure of the wine cellar
to the desired controller mounting location.
Important