Table of Contents
Advertisement
Do not install in the following locations that may result in damage
●
A location subject to dramatic changes in temperature or
humidity
●
A location near equipment that generates magnetic or
electromagnetic waves
●
A laboratory or location where chemical reactions occur
●
A location exposed to corrosive or toxic gases
●
A location that may warp from the weight of the machine or
where the machine is liable to sink (a carpet, etc.)
●
A location near televisions, radios, or similar electronic
equipment
Avoid poorly ventilated locations
This machine generates a slight amount of ozone, etc. during normal use. Although sensitivity to ozone, etc.
may vary, this amount is not harmful. Ozone, etc. may be more noticeable during extended use or long
production runs, especially in poorly ventilated rooms. It is recommended that the room where the machine
operates be appropriately ventilated to maintain a comfortable working environment. Also avoid locations
where people would be exposed to emissions from the machine.
Do not install in a location where condensation occurs
Water droplets (condensation) may form inside the machine when the room where the machine is installed is
heated rapidly, and when the machine is moved from a cool or dry location to a hot or humid location. Using
the machine under these conditions may result in paper jams, poor print quality, or damage to the machine. Let
the machine adjust to the ambient temperature and humidity for at least 2 hours before use.
When using wireless LAN (imageRUNNER 2204F / 2204N / 2004N)
●
Set the machine at a distance of 50 m or less from the wireless LAN router.
●
Do not set machine in a location where any object blocks communication. The signal may be degraded when
passing through walls or floors.
●
Keep the machine as far as possible from digital cordless phones, microwave ovens, or other equipment that
emit radio waves.
Connecting the Telephone Line (imageRUNNER 2204F)
This machine conforms to an analog telephone line standard. The machine can be connected to the public
switched telephone network (PSTN) only. If you connect the machine to a digital telephone line or a dedicated
telephone line, it might impede proper operation of the machine and could be the cause of damage. Make sure
to confirm a type of telephone line before connecting the machine. Contact your optical fiber line or IP
telephone line service providers if you want to connect the machine to those telephone lines.
Avoid installing the machine at high altitudes of about 3,000 meters above sea level, or
higher
Machines with a hard disk may not operate properly when used at high altitudes of about 3,000 meters above
sea level, or higher.
Important Safety Instructions
4
Advertisement
Table of Contents
