Table of Contents
Advertisement
A Different Application Opens When You Want to Scan a Document.
●
Register the appropriate application in the MF Toolbox.
Scanning Using MF Toolbox(P. 223)
Cannot Scan Highlighting Marks.
●
Followings are solutions for scanning the highlighting marks.
- Darken the highlighted marks by adjusting the white-point.
- Emphasize the highlighted marks by adjusting the tone curve settings.
- Darken the highlighted marks by adjusting the brightness.
- Lower the monitor gamma value.
Configuring Scan Settings in Advanced Mode(P. 243)
Distortion Patterns (moire) Appear On the Scanned Images
●
Specify <Scan Mode> of MF Toolbox to <Color (Magazine)>. If you cannot change <Scan Mode> of MF
Toolbox, specify <Select Source> in the Basic Mode of ScanGear MF to <Magazine (Color/Platen Glass)>.
Configuring Scan Settings in Simple Mode(P. 240)
●
If the condition does not get improved, clear <Use Unsharp Mask> check box in the Advanced Mode of
ScanGear MF.
Configuring Scan Settings in Advanced Mode(P. 243)
Troubleshooting
510
Advertisement
Table of Contents
