Connect The Harness Cable To The Boom Function Controls - Raven AutoBoom Installation Manual

Chapter 5
Secure the AutoBoom node (P/N 063-0130-013) to the node mounting bracket (P/N 107-0171-619) using
1.
three 3/8"-16 x 1-1/4" zinc hex bolts (P/N 311-0054-105) and three 3/8"-16 zinc flanged lock nuts (P/N 312-
1001-164).
Note:
Position the node so that the cable connectors point down.
Insert the large, rectangular node connectors into the correct ports of the AutoBoom node.
2.
Tighten the bolts on the node connectors to secure the connections.
3.
Secure the mounting bracket to the cross rail using two 4" W x 5" L x 3/8" thread U-bolts (P/N 107-0171-
4.
606) and four 3/8"-16 zinc flanged lock nuts (P/N 312-1001-164).
Connect the Harness Cable to the Boom
Function Controls
AutoBoom Valve Connections
FIGURE 2.
Locate the LEFT PRESS and RIGHT PRESS connectors on the AutoBoom harness cable (P/N 115-0230-
1.
108).
Route the connectors to the AutoBoom valve (P/N 063-0131-125).
2.
Connect the LEFT PRESS (PORT G1) connector to Port G1 of the AutoBoom valve.
3.
Connect the RIGHT PRESS (PORT G4) connector to Port G4 of the AutoBoom valve.
4.
Locate the LEFT SOLENOID and RIGHT SOLENOID connectors on the harness cable.
5.
Connect the LEFT SOLENOID (PORT LF) connector to Port 4A of the AutoBoom valve.
6.
Connect the RIGHT SOLENOID (PORT RT) connector to Port 4B of the AutoBoom valve.
7.
Locate the LEFT PROP and RIGHT PROP connectors on the harness cable.
8.
Connect the LEFT PROP (PORT 5A) connector to Port 5A of the AutoBoom valve.
9.
Connect the RIGHT PROP (PORT 13A) connector to Port 13A of the AutoBoom valve.
10.
26
Hagie STS, Model Year 2007-2013 AutoBoom™ Installation Manual