5.2.1
Power supply
The DTI is supplied with 8 1.5 Volt batteries as standard. When the
battery voltage is low following message will appear:
This message will only appear one time after the DTI has been
switched on, and is removed by pressing the key <Menu/Enter> or
<Reset/Select>. The DTI is still able perform accurate measurements
a little while longer.
The batteries are placed in the two battery holders shown in the
figure below:
2 x 4 PCS BATTERIES TYPE AA
RS 232
It is also possible to supply the DTI from a mains adapter at the
connector shown in the figure above. The mains adapter can be
supplied by AMETEK.
124745 04
BATTERY LOW
PRESS ANY KEY
9VDC
-
200 mA
2017-08-10
Mains adapter
17