5.2.2
On / Off
Start the DTI by activating the softkey <ON/Off>. Following message
will be shown in the display:
This information states that the internal references and the sensor
coefficients are checked. If the coefficients are incorrect an error
message will occur which is described in section 7.3.
The next message shown in the display will be:
In this step the A/D converter is calibrated which approximately takes
1 second. When the calibration is over following message will be
shown:
Test 3 is an internal voltage reference check, which approximately
takes 4 seconds.
When all tests have succeeded, the DTI will show the model type and
last calibration date in the display:
18
SELF-CALIBRATION
AND TESTING 1
SELF-CALIBRATION
AND TESTING 2
SELF-CALIBRATION
AND TESTING 3
Ver. X.XX
CAL. DATE 031216
2017-08-10
DTI-1000
124745
04