Safety Instructions - Ametek Jofra DTI-1000 A Reference Manual

2.0

Safety instructions

Read this manual carefully before using
the instrument!
Please follow the instructions and procedures
described in this manual. They are designed to allow
you to get the most out of your DTI system and avoid
any personal injuries and/or damage to the instrument.
Disposal – WEEE Directive
These calibrators contain Electrical and Electronic
circuits and must be recycled or disposed of properly
(in accordance with the WEEE Directive 2012/19/EU).
Warning
•
•
•
•
•
•
•
6
The indicator must not be used for any purposes
other than those described in this manual, as it
might cause a hazard.
The indicator has been designed for indoor use
only and is not to be used in wet locations.
The indicator is not to be used in hazardous
areas, where vapour or gas leaks, etc. may
constitute a danger of explosion.
The indicator is not designed for operation in
altitudes above 2000 meters.
Only use the specified mains adaptor approved for
the voltage and plug configuration in your area.
Do not connect rated voltages to earth with a
maximum above 30V to the input terminals.
Always position the indicator to enable easy and
quick disconnection of the power source (mains
adaptor).
2017-08-10 124745 04