7.0
Maintenance and display error
messages
7.1
Maintenance
The DTI does not require specific maintenance before or after use.
The user may carry out the following procedures himself.
Cleaning surfaces
Re-calibrate or change
coefficients for sensors
Re-calibration of DTI
references or analog out
7.2
Changing batteries
The batteries are placed in the two battery holders shown in the
figure below. The battery holders can be pulled out by pressing the
locks on both sides simultaneously.
2 x 4 PCS BATTERIES TYPE AA
RS 232
30
Use alcohol or water and a soft cloth.
Use the software in order to re-
calibrate/change the sensor
coefficients (see section 8.0).
Use the calibration routines in the
software to re-calibrate the DTI (see
section 8.0).
9VDC
-
200 mA
2017-08-10
Press
124745
04