S05 Foot Switch - QuadTech Sentry Plus Series Instruction Manual

3.5

S05 Foot Switch

The S05 Foot Switch provides hands-free remote testing capability. The spade leads on the S05
Foot Switch are connected (screwed) to the terminal strip on the rear panel of the Sentry Plus
Series instrument.
1. Connect (screw) the white wire/spade connector to the START terminal.
2. Connect (screw) the red wire/spade connector to the COM terminal.
Figure 3-9 illustrates this connection of the S05 Foot Switch to a Sentry 30 Plus instrument.
WARNING: FOR CONTINUED PROTECTION
! AGAINST FIRE HAZARD, REPLACE ONLY WITH
THE SAME TYPE AND RATING OF FUSE AS
SPECIFIED FOR THE LINE VOLTAGE BEING
UTILIZED.
CAUTION: NO OPERATOR SERVICEABLE PARTS
!
INSIDE. REFER SERVICING TO QUALIFIED
PERSONNEL.
POLLUTION DEGREE 2
INSTALLATION CATEGORY II
VOLTAGE SELECTOR
90V - 110V ~
108V - 132V ~
198V - 242V ~
216V - 250V ~
MODEL NO.
SERIAL NO.
HIGH VOLTAGE
Max 5kVAC/6kVDC
HV OUTPUT RTN/LOW
Interface
Terminal Strip rear of Sentry 30 Plus
1 5
6 9
CONT. CHECK OPTION
3.15AT
250V
1.6AT
250V
100V/120V/220V/240V~
50/60Hz 300W MAX
White
Wire &
Spade
to
Terminal
Strip:
START
Figure 3-9: S05 Foot Switch
FAN 50
START
RESET
COM
INTER
LOCK
Red
Wire &
Spade
to
Terminal
Strip:
COM
S05 Foot Switch
o
C AUTO ON/OFF
Page 73 of 85