S03 Corded Product Adapter - QuadTech Sentry Plus Series Instruction Manual

3.4 S03 Corded Product Adapter (115V)
The S03 Corded Product Adapter is a 3-prong electrical outlet box to facilitate testing of corded
products. The S03 cable is connected to the Sentry Plus Series instrument via a two-lead set.
1. Connect the black banana plug to the Sentry Plus RTN/LOW.
2. Connect the white banana plug to the Sentry Plus OUTPUT terminal.
3. Plug the DUT's 3-wire power cord into the S03 corded product adapter.
4. For GC test, connect GC Lead (700100) to rear Sentry Cont Check terminal and metal on
case of DUT.
Figure 3-8 illustrates this connection of the S03 cable to a Sentry 30 Plus instrument.
WARNING: FOR CONTINUED PROTECTION
! AGAINST FIRE HAZARD, REPLACE ONLY WITH
THE SAME TYPE AND RATING OF FUSE AS
SPECIFIED FOR THE LINE VOLTAGE BEING
UTILIZED.
CAUTION: NO OPERATOR SERVICEABLE PARTS
!
INSIDE. REFER SERVICING TO QUALIFIED
PERSONNEL.
POLLUTION DEGREE 2
INSTALLATION CATEGORY II
VOLTAGE SELECTOR
90V - 110V ~
108V - 132V ~
198V - 242V ~
216V - 250V ~
MODEL NO.
SERIAL NO.
HIGH VOLTAGE
Max 5kVAC/6kVDC
HV OUTPUT RTN/LOW
STOP
START
1 0
DUT (Monitor)
Page 72 of 85
1 5
6 9
CONT. CHECK OPTION
3.15AT
250V
1.6AT
250V
100V/120V/220V/240V~
50/60Hz 300W MAX
Q
uadTech
Sentry 30 Plus AC/DC/IR Hipot Tester
CAL UPDATE PASS
3
DUT plugged into
S03 Adapter
DO NOT TOUCH WHILE UNDER TEST
S03 Corded
Product Adapter
Figure 3-8: S03 Corded Product Adapter
START
RESET
COM
INTER
LOCK
FAIL DANGER
!
CAUTION
Max 5kVAC
6kVDC
Black
1
Banana
Plug
to
RTN/LOW
QuadTech
20A 125V
MAX. VOLTAGE
5kVAC
6kVDC
o
FAN 50 C AUTO ON/OFF
F1
F1 F2
F2
F3
F3
F4
F4
OUTPUT
RTN/LOW
Hipot
Custom
Connection
White
Banana
Plug
to
OUTPUT
Interface
2