Storing A Test Setup - QuadTech Sentry Plus Series Instruction Manual

2.9

Storing a Test Setup

Instrument PRESET values can be programmed and stored for your specific test setup. Therefore
before storing your tests, program the preset values. Refer to p 2.11 for PRESET programming
To store the previous example of the programmed 5-step test, with the instrument in 'STAND
BY' status, press [F3] = MENU to access the memory function.
In MENU with the highlighted box around MEMORY, press [F3] = SELECT to enter the
memory function.
0.1A
1.2 Ω
STAND BY
Display
0.5s
STAND BY
1 MEMORY
2 SYSTEM
3 OPTION
MENU
4 CALIBRATION
5 KEY LOCK
SELECT FUNC.
1 (0 STEPS)
2 (0 STEPS)
3 (0 STEPS)
MEMORY
4 (0 STEPS)
5 (0 STEPS)
SELECT FUNC.
Press [F1] = STORE to access the store function. Press [F2] = DOWN to move highlighted box
to the memory location (1-60) in which you wish to store this test setup. Press [F3] = SELECT
to accept location number.
1 (0 STEPS)
2 (0 STEPS)
Select
3 (0 STEPS)
4 (0 STEPS)
LOCATION
5 (0 STEPS)
SEL. MEMORY
Operation
information.
STEP 1/5 GC
RMT LOCK
RMT LOCK
RMT LOCK
RMT LOCK
NOTE:
LOW : 0.3Ω
PROGRAM
PRESET
MENU
MORE..
OFST ERR
LAST
DOWN
SELECT
EXIT
OFST ERR
STORE
RECALL
DELETE
RETURN
OFST ERR
LAST
DOWN
SELECT
RETURN
OFST ERR
F1 To enter programming mode.
To view/change preset (initial) test
F2
parameters.
To view/change system parameters:
F3 memory, system, option, calibration, key
lock, password, error, & about.
To view the programmed test setups and
F4
access offset function.
F1 To toggle through MENU functions.
F2 To toggle through MENU functions.
F3 To enter MEMORY function.
F4 Return to STAND BY display.
To store a test setup in memory
F1
location 1-60
F2 Recall test in highlighted location.
F3 Delete test in highlighted location.
F4 Return to MENU display.
To move highlighted box to
F1
memory location 60
To toggle through memory
F2
locations 1-60
To select highlighted memory
F3 location and store previously
programmed test setup
F4
Page 45 of 85