Controls And Indicators; Front Panel Controls And Indicators - QuadTech Sentry Plus Series Instruction Manual

1.3

Controls and Indicators

1.3.1 Front Panel Controls and Indicators

Figure 1-2 illustrates the controls and indicators on the front panel of the Sentry Plus Series
AC/DC/IR Hipot Tester. Table 1-1 identifies them with description and function.
STOP
3
START
2
1 0
1
Figure 1-2: Sentry 30 Plus Front Panel Controls & Indicators
Table 1-1: Sentry 30 Plus Front Panel Controls & Indicators
Reference Name
Number
Figure 1-2
1 Power
2 START
3 STOP
4 Display
5 F1, F2, F3
and F4
6 OUTPUT
7 RTN/LOW
8 DANGER
9 FAIL
10 PASS
11 UPDATE
12 CAL
Page 22 of 85
Q
uadTech
Sentry 30 Plus AC/DC/IR Hipot Tester
CAL UPDATE PASS FAIL
12 11 10 9
Type
Green Push Button
Green Push Button
Red Push Button
LCD
Gray Push Buttons
White Custom
Banana Socket
Blue Banana Socket
Red LED
Red LED
Green LED
Recessed P-B
Recessed P-B
4
F1
F2
F3
F4
DANGER
!
CAUTION
Max 5kVAC
6kVDC
8
Function
Apply AC Power: 1=ON, 0=OFF
Initiate Test: HV applied to OUTPUT terminal
Stop Test: HV terminated at OUTPUT terminal
Program Menu, Test Setup, Measurement Results,
Memory Contents, Calibration
Select Instrument Functions
Keys perform different functions under different menus.
Right side of display shows corresponding key function.
High Voltage (Potential) Terminal
RTN: Low voltage reference terminal
LOW: Common ground reference terminal
When lit, high voltage is present at OUTPUT terminals
When lit, DUT judged as FAIL. Output voltage is
immediately cut off. Press [STOP] to disable FAIL LED
When lit, DUT judged as PASS
Qualified Service Personnel Only
Enable/Disable Instrument Calibration
5
F1
F2
F3
F4
OUTPUT
RTN/LOW
7
Introduction
6