Cannot Print Properly From A Digital Camera - Canon MultiPASS MP390 User Manual

Message
TRY AGAIN IN
B&W
TX/RX
CANCELLED
TX/RX NO.
nnnn
WASTE INK NEAR
FULL
WRONG CARTRIDGE The print head is not installed

Cannot Print Properly From A Digital Camera

The following messages may be displayed on the Canon "Bubble Jet Direct" compatible digital
camera or digital video camcorder when images are printed directly from them. Take the
appropriate action to correct the error.
• Different messages may be displayed on "PictBridge" compatible digital cameras or digital video
camcorders. Refer to the user's manual for the digital camera or digital video camcorder.
• Images can be printed directly from "PictBridge" and Canon "Bubble Jet Direct" compatible
digital cameras and digital video camcorders connected to this machine.
• If the operation time or data transmission time is too long when the digital camera or digital video
camcorder is connected to this machine, a communication time error may occur and no more
images can be printed. If this error occurs, disconnect all connected cables, press [Stop/Reset],
then reconnect the cables. The digital camera will automatically turn ON. If not, turn it ON.
• A low ink warning is not displayed on the digital camera or digital video camcorder.
• After replacing an ink tank, disconnect the digital camera from the machine and reset the ink
counter. (See page 112)
• If the ink counter is not reset, the remaining ink level may not be displayed properly.
• For more details, refer to the user's manual for the digital camera or digital video camcorder.
For a problem with the digital camera or digital video camcorder, contact the service center for the
camera.
Chapter 13
Cause
The recipient's fax machine is
not color-compatible.
You pressed [Stop/Reset] to
cancel the transmission.
When the machine sends or
receives a fax, it assigns a
unique identification number
(nnnn).
The waste ink tank (which
holds the ink used for print
head cleaning) is nearly full.
correctly.
Action
Press [Black] to resend the faxes.
If required, try sending or receiving
again.
Write the number down if you will
need it later.
Contact the Canon Customer Care
Center.
Install the print head. If the message
remains on the LCD, the print head
may be defective. Contact the
Canon Customer Care Center.
Troubleshooting
Details
—
—
page 102
—
Set-Up
Sheet
147