Setting The Power Save Timer - Canon MultiPASS MP390 User Manual

Setting The Power Save Timer

Power Save mode allows the scanning lamp is shut off, based on the length of time you specify
using the Power Save Timer setting. If you perform an operation immediately after recovering from
Power Save mode, the image may not be correctly read by the machine. If you use the machine
frequently, we recommend that you set the Power Save Timer to <4 HOURS> or <8 HOURS>.
IMPORTANT
• After recovering from Power Save mode, wait at least one minute before scanning, copying, or sending
faxes.
• The default setting is <1 HOUR>.
Follow this procedure:
1
Press [Additional Functions].
2
Use [ ] or [ ] to select <10.POWER SAVE TIMER>.
USER DATA
10.POWER SAVE TIMER
3
Press [Set].
Ex:
POWER SAVE TIMER
4
Use [ ] or [ ] to select the time to switch the machine to Power Save
mode.
– <1 HOUR>:
– <4 HOURS>:
– <8 HOURS>:
5
Press [Set].
120
Maintenance
1 HOUR
Switches the machine to Power Save mode if any key on the operation panel
is not pressed for one hour.
Switches the machine to Power Save mode if any key on the operation panel
is not pressed for four hours.
Switches the machine to Power Save mode if any key on the operation panel
is not pressed for eight hours.
Chapter 12