When The Alarm Lamp Flashes; Nothing Displays On The Lcd (There Is No Power) - Canon MultiPASS MP390 User Manual

When The Alarm Lamp Flashes

If paper has run out, ink has run low, or a paper jam occurs while printing, the Alarm lamp flashes.
Check the cause of the error below and take corrective actions.
Cause
The Alarm lamp flashes.

Nothing Displays On The LCD (There Is No Power)

When you connect the power cord to the machine and wall outlet, and press [ON/OFF], the
machine powers ON and a message is displayed on the LCD.
While the Alarm lamp flashes, the machine is initializing and you will not be able to use it. Wait
until the Alarm lamp stops flashing.
If nothing is displayed on the LCD, check the cause of the following.
Cause
The power cord is not correctly
connected.
You have not pressed [ON/OFF]. The machine will power ON and the LCD will display a message
The wall outlet is not working
normally.
The power cord is connected to a
table tap or extension cord.
The power cord is defective.
Chapter 13
If a message appears:
1. Check the message appearing on the LCD.
2. Follow the instructions and correct the error.
For LCD messages, see page 143.
3. Press [Set] to resume operation.
• The Alarm lamp will stop flashing.
• If the error remains, turn OFF the machine and disconnect the
power cord. Wait at least 15 seconds then reconnect the power
cord and turn ON the machine.
If a message does not appear:
1. Turn OFF the machine and disconnect the power cord.
2. Wait at least five seconds, reconnect the power cord and turn the
power ON.
If the problem has been resolved, the Alarm lamp will stop
flashing.
If the Alarm lamp still flashes even after you have turned the
power ON again:
Contact the Canon Customer Care Center.
Securely connect the power cord to the machine and wall outlet.
when you connect the power cord and press [ON/OFF].
Connect an electrical appliance to the wall outlet and check whether
the wall outlet is working properly.
If the table tap or extension cord has a power switch, check that it is
turned ON. If the machine does not power ON, disconnect it from the
table tap or extension cord and connect the machine directly to the
wall outlet.
Either replace the power cord with another, suitably fused, or using
a tester, check whether the cord is defective.
Action
Action
Troubleshooting
127