Cannot Print Properly From A Digital Camera (Mp370) - Canon MultiPASS MP360 User Manual

Cannot Print Properly From A Digital Camera (MP370)

The following messages may be displayed on the digital camera or digital video camcorder when
images are printed directly from them. Take the appropriate action to correct the error.
• Images can be printed directly from "PictBridge" and Canon "Bubble Jet Direct" compatible
digital cameras and digital video camcorders connected to this machine.
• If the operation time or data transmission time is too long when the digital camera or digital video
camcorder is connected to this machine, a communication time error may occur and no more
images can be printed. If this error occurs, disconnect all connected cables, press [Stop/Reset],
then reconnect the cables. The digital camera will automatically turn ON. If not, turn it ON.
• A low ink warning is not displayed on the digital camera or digital video camcorder.
• After replacing an ink tank, disconnect the digital camera from the machine and reset the ink
counter. (See page 80)
• If the ink counter is not reset, the remaining ink level may not be displayed properly.
• For more details, refer to the user's manual for the digital camera or digital video camcorder.
For a problem with the digital camera or digital video camcorder, contact the service center for the
camera.
Error Message On Camera
Printer in use
Printer warming up.
No paper
Paper jam
Printer cover open
No print head
Waste tank full
Paper lever error
Printer error
110
Troubleshooting
Cause
Images are being printed from
the computer.
Printer is warming up for
printing.
No paper is loaded.
A paper jam has occurred in the
machine.
The scan unit is open.
• No print head is installed.
• The print head is defective.
The waste ink tank is nearly
full.
Incorrect position of the paper
thickness lever.
An error requiring servicing
has occurred.
Action
Wait until printing ends.
Wait until warm-up ends.
Load the paper in the multi-purpose tray and
press [Set].
Remove the jammed paper, load new paper, and
press [Set].
Return the scan unit to its original position.
• Install a print head.
• Contact the Canon Customer Care Center.
Press [Stop/Reset] on the machine to recover
from the error. Printing can continue for a little
while. However, when the waste tank becomes
full, printing will be disabled. Contact the
Canon Customer Care Center as soon as
possible.
Adjust the paper thickness lever to the left
position (for plain paper).
Turn OFF the machine, unplug the power cord
from the power supply, plug the power cord back
in after 15 seconds, and then turn ON the
machine. If the same error occurs, contact the
Canon Customer Care Center.
Chapter 11