Canon MultiPASS MP390 User Manual page 168

CAUTION
You may cause injury or damage the machine if you ignore any of these safety precautions.
Location
Do not block or cover the ventilation port or any openings on the machine with objects, as it may
cause the inside of machine to overheat and cause a fire.
Place the machine on a flat, stable, vibration-free surface that is strong enough to support its
weight. If the machine topples over, it may result in injury. (For the weight of the machine, see
the Appendix.)
Do not use or store the machine outdoors.
Do not install the machine near devices that contain magnets or generate magnetic fields, such as
speakers.
To ensure proper ventilation, make sure the machine is approximately 4 inches (10 cm) away from
walls and other equipment.
Do not install the machine in a location that is very humid or dusty, in direct sunlight, outdoors,
or close to a heating source.
Installing in such a location may result in fire or electrical shock.
To avoid the risk of fire or electrical shocks, install the machine in a location with an ambient
temperature range of 59°F to 81.5°F (15°C to 27.5°C) and humidity of 20% to 80% (condensation
free).
Do not place the machine on a thick rug or carpet.
If fibers or dust come inside the machine, it could cause a fire.
Power supply
Never remove the plug by pulling on the cord.
Pulling on the power cord may damage the cord and cause a fire or electrical shock.
When turning OFF the power, be sure to press [ON/OFF] or unplug the machine.
However, if the machine is unplugged during printing, the print head is not protected with the cap
that prevents the ink from drying. This may affect the print quality of the machine when printing
later.
During electrical storms, turn OFF the power and disconnect the power cord from the power
outlet.
Do not use an extension cord as this may result in fire or electrical shock.
Ensure that the area around the power outlet is kept clear at all times so you can easily unplug the
power cord if necessary. Otherwise you will be unable to disconnect the power plug in case of an
emergency, and it may result in fire or electrical shock.
Never use a power supply source other than the one rated for the machine in the country where
you purchased the machine as it may result in fire or electrical shock.
The operating requirement of this machine is as follows:
120V AC, 60 Hz
166
Appendix Chapter 14