Emc Directive - Canon MultiPASS L60 User Manual

EMC Directive

This equipment has been tested in a typical system to comply with the
technical requirements of the EMC directive. Use of a shielded cable is
necessary to comply with the technical requirements of the EMC
Directive.
For your safety (Australia only)
To ensure safe operation the three-pin plug supplied must be inserted
only into a standard three-pin power point which is effectively earthed
through the normal household wiring.
Extension cords used with the equipment must be three-core and be
correctly wired to provide connection to earth. Wrongly wired extension
cords are a major cause of fatalities.
The power point shall be located near the equipment and shall be easily
accessible.
The fact that the equipment operates satisfactorily does not imply that
the power point is earthed and the installation is completely safe. For
your safety, if in any doubt about the effective earthing of the power
point, consult a qualified electrician.
Caution (New Zealand only)
1. This equipment may not necessarily provide for the effective hand-
over of a call to or from a telephone connected to the same line.
2. The operation of this equipment on the same line as telephone or
other equipment with audible warning devices or automatic ring
detectors will give rise to bell tinkle or noise and may cause false
tripping of the ring detector. Should such problems occur, the user is
not to contact Telecom faults service.
3. Should this equipment become physically damaged, disconnect
immediately from the Telecom connection and power source and
contact your nearest service agent.
Preface
v